This is an old revision of the document!
This page here contains STLs that are not required for building your Gugusse Compact but you might find the items here practical, if you were looking for the STLs to build the Gugusse Compact, you will find it here: Gugusse Compact
35mm film splicer
I would not recommend this splicer if you want to use it for a 35mm projector, but for the Gugusse Compact it will do a better job than any real splicer. the Gugusse doesn't use sprockets like a projector and therefore doesn't react well to film holes that are covered with tape, it doesn't push the excess tape out of the way. Tape over film holes has a good chance to make you lose your registration sync. I personnally use this splicer with archival scotch tape (looks like regular scotch tape), I only tape the width of the picture and leave the holes uncovered.
The way to use is simple, you align the film and then use a cutter in the middle groove while applying the cover over one half
