build_your_own_electronic_board
This is an old revision of the document!
Building the Gugusse 2.2 PCB
You're going to need an empty Gugusse 2.2 Printed Circuit Board to start. These can be ordered from any company that produces PCBs in small quantities. The files you need are called Gerber Files and the PCB is 8cm x 10cm. The Gerber files are included in the Gugussse Compact distribution. Below is a parts list of what you'll need to build it. DigiKey part numbers are included but you can use any parts supplier that can provide the same parts.
Download Complete instructions
| ITEM | DIGIKEY PART # | QTY | NOTES |
|---|---|---|---|
| CONN HEADER VERT 4POS 2.5MM | 455-2249-ND | 6 | |
| CONN HEADER VERT 2POS 2.54MM | WM4800-ND | 1 | |
| CONN HEADER VERT 4POS 5.08MM | A1212-ND | 1 | |
| METRO MINI 328 V2 CP2102N USB C | 1528-1374-ND | 1 | |
| TMC2209 STEPPER DRIVER BOARD | 1460-TMC2209SILENTSTEPSTICK-ND | 3 | |
| LOGIC LEVEL CONVERTER - BI-DIREC | 1568-1209-ND | 1 | |
| IC COMPARATOR 1 GEN PUR 8DIP | 296-6617-5-ND | 2 | |
| TRANS NPN DARL 60V 5A TO220 | TIP120GOS-ND | 3 | |
| RES 1K OHM 2% 1/4W AXIAL | 2368-QW210-ND | 3 | There may be cheaper options |
| RES 10K OHM 2% 1/4W AXIAL | 2368-QW310-ND | 4 | There may be cheaper options |
| RES 100K OHM 2% 1/4W AXIAL | 2368-QW410-ND | 3 | There may be cheaper options |
| RES 500K OHM 1% 1/4W AXIAL | 1135-1620-ND | 1 | There may be cheaper options |
| RASPBERRY PI GPIO TALL HEADER | 1568-1462-ND | 1 | |
| CONN SIL HDR MALE PIN 32POS TIN | 952-2521-ND | 3 | (Buy an extra at least) |
| SMALL ADHESIVE HEAT SINK | 3 | See picture |
build_your_own_electronic_board.1691415266.txt.gz · Last modified: 2023/08/07 09:34 by al
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
