This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
things_to_buy [2024/04/01 13:45] al |
things_to_buy [2024/10/05 05:06] (current) meantux |
||
---|---|---|---|
Line 44: | Line 44: | ||
| Housings Receptacle White 0.098" (2.50mm) | 2 | Digikey 455-2267-ND | | | Housings Receptacle White 0.098" (2.50mm) | 2 | Digikey 455-2267-ND | | ||
| Small Wire Ties | Many | For holding wires together. | | | Small Wire Ties | Many | For holding wires together. | | ||
+ | |||
+ | ===== Remaining Purchased Parts Required: ===== | ||
+ | |||
+ | ^ ITEM ^ QTY ^ NOTES ^ | ||
+ | | 2’ x 2’ x ½” (70cm X 70cm x 13mm) Wooden Board | 1 | Everything will be attached to it. | | ||
+ | | 10” x 10” (25cm x 25 cm) Steel Plate | 1 | We found a galvanized steel “Sign” at a craft store. | | ||
+ | | Hot Glue Gun w/Glue | 1 | Get a decent one that doesn’t drip. | | ||
+ | | Double Sided Carpet Tape | 20” | Used to hold down metal plate but hot glue would work as well. | | ||
+ | | Main Base Assembly (from above) | 1 | | | ||
+ | | Turntable w/Shoe (from above) | 2 | | | ||
+ | | PC Power Supply (AT or ATX) | 1 | Must have a connector to power the Gugusse PCB | | ||
+ | | Gugusse 3.1 PCB (assembled) | 1 | | | ||
+ | | Raspberry Pi 4B (4GB or more) w/SD 16GB+ | 1 | | | ||
+ | | Raspberry Pi HQ Camera with Lens, Extended Cable, and Adapters. | 1 | Many Lens options here. Suggest Edmunds Optics 17.5mm FL f/5.6, Blue Series M12 Lens - #83-943 / C-Mount to M12 Adapter for UCi Lens - #12-879 – 2X 5mm C-Mount Extension (eBay) | | ||
+ | | Configured EX-DN10 Hole Sensor | 1 | Found at Ali Express - Needs additional parts - See PCB documentation | | ||
+ | | M2.5 x 16mm Bolt | 2 | To Mount Camera | | ||
+ | | M2.5 Nut | 2 | To Mount Camera | | ||
+ | | #6 X 3” Bolt | 1 | | | ||
+ | | #6 Nut | 1 | | | ||
+ | | Neodymium Magnets | 8 | Ours are 2.2 x 1.5cm – Anything around that size will work. | | ||
---- | ---- |