disclaimer
Differences
This shows you the differences between two versions of the page.
|
disclaimer [2023/07/29 18:57] 127.0.0.1 external edit |
disclaimer [2023/07/29 20:28] (current) admin |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| - This will produce a plastic machine with plastic flywheels, this will not give the same result as if they were made like clockwork with metal, so they require a lot of post-processing to stabilize the resulting pictures. You can see what it can do in this channel: [[https://www.youtube.com/channel/UCKRNF9QvmIiL1MzkNluiv1Q|Youtube channel]] . | - This will produce a plastic machine with plastic flywheels, this will not give the same result as if they were made like clockwork with metal, so they require a lot of post-processing to stabilize the resulting pictures. You can see what it can do in this channel: [[https://www.youtube.com/channel/UCKRNF9QvmIiL1MzkNluiv1Q|Youtube channel]] . | ||
| - There is no rewind system, I have used a drill and some tape (in the other hand you are not required to rewind, you can capture backward and reverse it back in post). You can also use Hand Rewinds often found on eBay. | - There is no rewind system, I have used a drill and some tape (in the other hand you are not required to rewind, you can capture backward and reverse it back in post). You can also use Hand Rewinds often found on eBay. | ||
| - | - At the start of the project I intended it to be a system without friction for the film <del>but at the end I had to settle for a slight pressure over 3 polished metal bars, you got to be careful not to choose the side with emulsion to rub these metal bars or once in a while, when some dirt get stuck between the film and the bar, you'll be adding scratches on your film and they sometimes may be colorful.</del> | ||
| - To have some film tension you need the film to be tightly spooled on its reel, if the film is too loose you'll have to perform an heresy and tighten it, I remember seeing an old movie of DOs and DON'Ts about films that explicitly advised to not tight a film on a spool. | - To have some film tension you need the film to be tightly spooled on its reel, if the film is too loose you'll have to perform an heresy and tighten it, I remember seeing an old movie of DOs and DON'Ts about films that explicitly advised to not tight a film on a spool. | ||
| - | - <del>Super8 film holes are very small and more difficult to detect. It takes a bit more time to adjust the hole sensor.</del> | ||
| - Although it's relatively easy to capture sound with the Gugusse when it's optical there is no way to capture it when it is a magnetic track. | - Although it's relatively easy to capture sound with the Gugusse when it's optical there is no way to capture it when it is a magnetic track. | ||
disclaimer.1690671474.txt.gz ยท Last modified: 2023/07/29 18:57 by 127.0.0.1
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
