build_your_own_electronic_board
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
build_your_own_electronic_board [2025/11/05 11:35] al Updated PDF with new Sensor instructions. |
build_your_own_electronic_board [2025/11/05 11:40] (current) al |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| | JUMPER SXH-001T-P0.6 | 455-3241-ND | 3 | | | | JUMPER SXH-001T-P0.6 | 455-3241-ND | 3 | | | ||
| | CONN RCPT HSG 4POS 2.50MM | 455-2267-ND | 1 | | | | CONN RCPT HSG 4POS 2.50MM | 455-2267-ND | 1 | | | ||
| - | | #6 x 3/4” Bolts with nuts. | Hardware Store | 3 | Optional – You can use tape as well. | | ||
| | Shrink Tubing – Various Sizes | Amazon or Digikey | | Get a kit with various sizes. | | | Shrink Tubing – Various Sizes | Amazon or Digikey | | Get a kit with various sizes. | | ||
| - | | Hot Glue | Hardware Store or Amazon | | Used to keep the Light Pipes from falling out of the EX-DN10 | | ||
| {{::img_0682.jpg?nolink&600|}} | {{::img_0682.jpg?nolink&600|}} | ||
build_your_own_electronic_board.1762360513.txt.gz · Last modified: 2025/11/05 11:35 by al
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
