build_instructions
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
build_instructions [2023/09/19 15:49] al |
build_instructions [2024/03/13 16:55] (current) al Added 3.1 Versions of the Instructions |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Build Instructions ====== | ====== Build Instructions ====== | ||
| + | This is the documentation page with instructions on how to assemble your Gugusse Compact with the Gugusse 3.1 PCB. The files you'll need to 3D print and the supporting files for the PCB are located on the [[list_of_materials|List Of Materials]] page. | ||
| ===== Turntables ===== | ===== Turntables ===== | ||
| You'll need two Turntables to feed and takeup film. Detailed build instructions below. | You'll need two Turntables to feed and takeup film. Detailed build instructions below. | ||
| Line 8: | Line 8: | ||
| ===== Main Base ===== | ===== Main Base ===== | ||
| - | The Main Base is the heart of the Gugusse Compact. Detailed build instructions below. Also below, is a template to print guidelines for the diffuser filters. | + | The Main Base is the heart of the Gugusse Compact. Detailed build instructions below. Also below, is a template to print guidelines for the diffuser filters. These instructions are to be used with the Gugusse 3.1 PCB. |
| {{::frontcad.jpg?nolink&600|}} | {{::frontcad.jpg?nolink&600|}} | ||
| - | Detailed Build Instructions: {{ ::compactmainbase1.0f.pdf |}} | + | Detailed Build Instructions: {{ ::compactmainbase_1.2.pdf |}} |
| Filter Template for Laser Printer: {{ ::gugussefilterv2.pdf |}} | Filter Template for Laser Printer: {{ ::gugussefilterv2.pdf |}} | ||
| - | ===== Legacy Instructions: ===== | + | ===== Layout Instructions ===== |
| + | This document shows how to put the various parts together so you can start using your Gugusse Compact. | ||
| + | {{:compactmain.png?nolink&600|}} | ||
| - | **How To assemble and connect the optocoupler.** | + | Detailed Layout Instructions: {{ ::gugusse_roller_layout_1_3.pdf |}} |
| - | {{:howtoassembleoptocoupler.png?800|}} | + | ===== Legacy Instructions: ===== |
| - | + | ||
| - | {{:howtoconnectholedetector.png?800|}} | + | |
| - | + | ||
| - | ---- | + | |
| {{:connect_stepper.png?600|}} | {{:connect_stepper.png?600|}} | ||
build_instructions.1695152995.txt.gz · Last modified: 2023/09/19 15:49 by al
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
